Serial servo controller firmware

This package has been written by Sage Telecommunications using the CCS compiler. It should be portable to other compilers and/or allow translation to other languages if required. The firmware ( 5k ) and test ( 1.9M mainly due to VB6 overhead ) software can be downloaded.

It was prototyped on a DT101 simmstick using a 16F84 but also runs with a 16C711 PIC.
It receives serial data via pin A.2
If pin A.0 is high then the serial data rate is 9600, if it is low then the baud rate is 2400.
Servo output is via port B ( B.0 is servo 1, B.1 is servo 2 etc )
A series resistor of ~4k7 should be used for each servo control line.
You will need to find the pinouts for your particular servo.
It is software compatible with the SSC controller by Scott Edward Electronics.

Simple RF modem serial routines example firmware

This firmware has been written by Sage Telecommunications using the CCS compiler. It should be portable to other compilers and/or allow translation to other languages if required. The firmware ( 7k ) can be downloaded.

The routines are not a complete application but should give you an basis for your own code.

This firmware is released as is for private, non commercial use. No warranty is implied or provided.

[ Home ] [ Up ]

Send mail to webmaster@sages.com.au with questions or comments about this web site.
Copyright © 1998-2024 Sage Telecommunications Pty Ltd
Last modified: February 24, 2024